TheBackShed.com

Home	JAQForum Ver 24.01
Log In or Join
Active Topics
Local Time 23:37 25 Nov 2024	Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : command SETUP on Duinomite ?

Author

Message

f1fco

Senior Member

Joined: 18/03/2012
Location: France
Posts: 154

Posted: 12:40pm 05 May 2012

Copy link to clipboard

Print this post

hello from F1FCO,
I own a Duinomite on version 2.7A
the command SETUP (v 1.3) is very useful for RTC card
I use OLIMEX MOD-RTC with PCF8563

my question : does this command SETUP (and use of RTC on boot) exist in version 3.1 or 3.2 of MMBASIC ?

thank you for answer

73s from F1FCO

73s de F1FCO

donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313

Posted: 05:01pm 06 May 2012

Copy link to clipboard

Print this post

f1fco said hello from F1FCO,
I own a Duinomite on version 2.7A
the command SETUP (v 1.3) is very useful for RTC card
I use OLIMEX MOD-RTC with PCF8563

my question : does this command SETUP (and use of RTC on boot) exist in version 3.1 or 3.2 of MMBASIC ?

thank you for answer

73s from F1FCO

Hi Pierre,

I also saw that you posted this question on KSD forum, and didn't get an answer.

To my knowledge, there is no "setup" command in standard V3.x MMbasic.

So you would either need to use DMbasic, or write a driver in MMbasic, to support the Olimex RTC.

Cheers Don...

https://www.dontronics.com

Print this page

To reply to this topic, you need to log in.