Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 19:59 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Duinomite mini VGA vs composite

Author Message
vk4tec

Senior Member

Joined: 24/03/2012
Location: Australia
Posts: 239
Posted: 03:05am 15 Apr 2012
Copy link to clipboard 
Print this post

Hello

At home I use s VGA screen 15 pin

Can the duinomite mini do composite ?

I want to add a little LCD composite to a gps project

What is the diff ? Pin connections ?

Firmware ?
Andrew Rich VK4TEC
www.tech-software.net
 
bigmik

Guru

Joined: 20/06/2011
Location: Australia
Posts: 2914
Posted: 05:51am 15 Apr 2012
Copy link to clipboard 
Print this post

  vk4tec said   Hello

At home I use s VGA screen 15 pin

Can the duinomite mini do composite ?

I want to add a little LCD composite to a gps project

What is the diff ? Pin connections ?

Firmware ?


Hi Andrew,

Yes it can, make up a special cable that has GND on a DB15-pin 7,8 or 10 and video out on DB-15 pin 1,2 or 3 connect these to an RCA connector. Make sure Pin 6 (the VGA/Composite select line is not connected to auto detect that Composite is required.

Use the SETUP command to select video mode (NTSC/PAL etc)

Regards,

MickEdited by bigmik 2012-04-16
Mick's uMite Stuff can be found >>> HERE (Kindly hosted by Dontronics) <<<
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024