Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 19:22 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : suggestions about CGMMSTICK1

Author Message
f1fco

Senior Member

Joined: 18/03/2012
Location: France
Posts: 154
Posted: 08:37am 14 Apr 2012
Copy link to clipboard 
Print this post

hello to all,
my english is very bad... (I use a translator word to word)

suggestions about the CGMMSTICK1 :
>the pin 4 is not connected, I use it for audio output (I link it with a short wire to audio out J5)
why not in a new design of the board ?

>the CGMMSTICK1 look like the SIMMSTICK (http://www.simmstick.com/whatissi.htm)
in a future design, is it possible to add a "pad" of copper near the 30 pins of J1
to connect the board on a 30 pin SIMM socket ?

73s from F1FCO (hamradio), Nimes, south of France
73s de F1FCO
 
CircuitGizmos

Guru

Joined: 08/09/2011
Location: United States
Posts: 1425
Posted: 04:56pm 14 Apr 2012
Copy link to clipboard 
Print this post

  f1fco said  
>the CGMMSTICK1 look like the SIMMSTICK (http://www.simmstick.com/whatissi.htm)
in a future design, is it possible to add a "pad" of copper near the 30 pins of J1
to connect the board on a 30 pin SIMM socket ?


The board would have to be made thinner and would also need to be rearranged slightly to be a Simmstick. Plus it would need to be notched.

The board wasn't meant for SIMM sockets, but was meant for solderless breadboards. It may have followed some of the spirit of the Simmstick, but it was not meant to be one.

You can make it in to one with an adapter.Edited by CircuitGizmos 2012-04-16
Micromites and Maximites! - Beginning Maximite
 
f1fco

Senior Member

Joined: 18/03/2012
Location: France
Posts: 154
Posted: 07:37pm 14 Apr 2012
Copy link to clipboard 
Print this post

ok Glenn, no problem
it was just a suggestion

and for audio output on pin 4 of J1 ?

F1FCO, Pierre
73s de F1FCO
 
CircuitGizmos

Guru

Joined: 08/09/2011
Location: United States
Posts: 1425
Posted: 07:01pm 15 Apr 2012
Copy link to clipboard 
Print this post

  f1fco said   ok Glenn, no problem
it was just a suggestion

and for audio output on pin 4 of J1 ?

F1FCO, Pierre


I'm not Glenn. If there is a redesign of the CGMMSTICK1, then the audio may be worth considering.
Micromites and Maximites! - Beginning Maximite
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024