 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Microcontroller and PC projects : How to install an uSD card on the CGMMSti
| Author | Message | ||||
| DuinoMiteMegaAn Senior Member  Joined: 17/11/2011 Location: AustraliaPosts: 231 |
The card will not pass over the firmware jumper and the metal crystal? This must be cruel joke or trick or a serious PCB layout problem? |
||||
BobD Guru  Joined: 07/12/2011 Location: AustraliaPosts: 935 |
No, if I recall correctly, the holder opens up like a hinge, you insert the card and then close it back down. CG has written a document on his creation and that may tell all. |
||||
| BobD Guru Joined: 07/12/2011 Location: AustraliaPosts: 935 |
Bigmik knows how. Look here http://www.thebackshed.com/forum/forum_posts.asp?TID=4572&PN =4 |
||||
| DuinoMiteMegaAn Senior Member Joined: 17/11/2011 Location: AustraliaPosts: 231 |
Whew ... gently pull back the SD holder to the edge horizonally to unlock then lift the sd holder hinge up then insert the card. Reverse the process. 
edited ... The CGMMStick is slick  |
||||
 Print this page |
