Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 07:50 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : (dm) period, frequency input

Author Message
herbnz

Senior Member

Joined: 18/02/2007
Location: New Zealand
Posts: 258
Posted: 07:53am 26 Jan 2012
Copy link to clipboard 
Print this post

Hi
I have been using the count input to measure a flow turbine. Decided to try Period works ok, period seems to be in millisec .

One question I do have is the reading is only interger numbers, can one switch to read the fractional part. The same applies to frequency .
Of course the count has to be whole numbers, hence the reason I thought I would try Period.
Herb
Edit was a mistake in original above count is 34 for 10 sec so 3.4 1 sec therfore 290 milsec correctEdited by herbnz 2012-01-27
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024