Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 07:38 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Maximite Tester

Author Message
johnbig

Newbie

Joined: 23/06/2011
Location: Australia
Posts: 21
Posted: 03:23am 14 Oct 2011
Copy link to clipboard 
Print this post

Has anyone thought about a testing module for the Maximite?
I was thinking about some hardware and a software solution to exercise all the i/o pins and 5 volt and 3.3 voltages. I think I have damaged pin 1 on my maximite because I got confused with the 26 pin i/o connector assignments between a cross over cable and straight cable and also hooked a 1.2 volt rechrgeable the wrong way around on pin 1 in the geoffg battery capacity tester.

John Leae
 
sparkey

Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 819
Posted: 12:20am 17 Oct 2011
Copy link to clipboard 
Print this post

i have put foward the basically same idea a while back ...this is a suggestion go to the maximite whish list its by "donmick" and leave a post there i think that somebody will do it eventully even if its just a straight led test board ..i would do it my self but ..i cannot code very well the hard whare would not be too difficult but some body woud have t write the code and ..i think things like loop back connectivity on the com ports ...etc..etc... i think there is good reason for this unit ....regards sparkey

and on a nother thought it may be possible just to run a diag program as long as the pins are tru to the software ....and not miss reported...

and on another point the analog pins are rated at 3.3 volts i/o....Edited by sparkey 2011-10-18
technicians do it with least resistance
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024