Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 02:08 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : Plastic Enclosure

Author Message
rofa
Newbie

Joined: 11/09/2011
Location:
Posts: 2
Posted: 07:34pm 10 Sep 2011
Copy link to clipboard 
Print this post

Can anybody tell me, what type of the plastic enclosure is used for the MM ?
I mean the white/grey box.
Thanks in advance,
Jiri
 
donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313
Posted: 07:40pm 10 Sep 2011
Copy link to clipboard 
Print this post

  rofa said   Can anybody tell me, what type of the plastic enclosure is used for the MM ?
I mean the white/grey box.
Thanks in advance,
Jiri


I was a little confused on this until Sparkey set me straight two days ago.

For the original board, it is an Altronics HO376 case. Snap together 130 x 75 x 28mm.

But it appears that it may not be listed in the latest catalogue, so I don't know if it can be purchased separately, or still available.

Cheers Don...Edited by donmck 2011-09-12
https://www.dontronics.com
 
ajkw
Senior Member

Joined: 29/06/2011
Location: Australia
Posts: 290
Posted: 10:40pm 10 Sep 2011
Copy link to clipboard 
Print this post

Altronics cat 2011-12 page 233 bottom left corner. Also on the website. Is part number H0376 not HO376, that is zero not O.
 
donmck

Guru

Joined: 09/06/2011
Location: Australia
Posts: 1313
Posted: 10:45pm 10 Sep 2011
Copy link to clipboard 
Print this post

  ajkw said   Altronics cat 2011-12 page 233 bottom left corner. Also on the website. Is part number H0376 not HO376, that is zero not O.


that b him

Cheers Don...
https://www.dontronics.com
 
rofa
Newbie

Joined: 11/09/2011
Location:
Posts: 2
Posted: 05:31pm 11 Sep 2011
Copy link to clipboard 
Print this post

Thank you very much.
Jiri
 
sparkey

Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 819
Posted: 05:55pm 11 Sep 2011
Copy link to clipboard 
Print this post

yes it is still a current stocked item
technicians do it with least resistance
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024