Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 02:18 24 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : analog negative inputs

Author Message
devigan
Newbie

Joined: 11/08/2011
Location: Australia
Posts: 26
Posted: 11:45pm 08 Sep 2011
Copy link to clipboard 
Print this post

Hi, any idea on reading plus minus 5 volt input. just wandering how to read negative voltage. Dave
 
aargee
Senior Member

Joined: 21/08/2008
Location: Australia
Posts: 255
Posted: 12:51am 09 Sep 2011
Copy link to clipboard 
Print this post

If it's on the same ground reference, the easiest thing would be to use an inverting/differential op-amp circuit. Have a Google of it...
For crying out loud, all I wanted to do was flash this blasted LED.
 
Xiongmao

Regular Member

Joined: 25/08/2011
Location: Australia
Posts: 48
Posted: 07:23am 09 Sep 2011
Copy link to clipboard 
Print this post

And if the grounds are different or you need isolation for other reasons, feed the voltage to a V/F chip and output that through an opto. Count the pulses to determine the voltage.
 
seco61
Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 205
Posted: 07:31am 09 Sep 2011
Copy link to clipboard 
Print this post

It all depends on your ground reference. If the -5V supply was completely independent of the Maximite, then (with an appropriate voltage divider network) you could connect the negative rail to the Maximite ground and the supply 0V line to the Maximite input. Then just subtract the appropriate amount from the result.

However, if there is any risk of common grounds then using an inverting op-amp as mentioned above is probably the way to go (and you can scale the voltage by using appropriate values in the op-amp circuit).

Regards

Gerard (vk3cg/vk3grs)
 
devigan
Newbie

Joined: 11/08/2011
Location: Australia
Posts: 26
Posted: 09:05am 09 Sep 2011
Copy link to clipboard 
Print this post

it's independent supply so I need some sort of a voltage divider. Thanks
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024