Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 23:37 22 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Microcontroller and PC projects : ok i`m a newbie here but what is 12c

Author Message
sparkey

Senior Member

Joined: 15/06/2011
Location: Australia
Posts: 819
Posted: 05:06pm 07 Jul 2011
Copy link to clipboard 
Print this post

ok fine i guess its a way of connectting a printer to certain pins on the maxi but softwhare wont do it alone u need to be able to con figure the hard whare to match this with ...look ..i can connect just about any thing i want to the maxi but to get it to communicate is a whole bottle of fish in a fish bowel ..regards spoarkey
technicians do it with least resistance
 
Ray B
Senior Member

Joined: 16/02/2007
Location: Australia
Posts: 219
Posted: 12:28am 08 Jul 2011
Copy link to clipboard 
Print this post

12C is a type of serial communications format similar to "1-Wire" which allows you to interface with a whole lot of addressable devices like very accurate (0.25C) digital temperature sensors, EEPROM, RTC etc all over the same pair of wires.

If you don't know the terms I'm using then GOOGLE them starting with Interfacing 12C

RayB from Perth WA
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024