 Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me. |
Forum Index : Other Stuff : Smartdrive uk
| Author | Message | ||||
| Dirtydirk Newbie  Joined: 14/02/2016 Location: United KingdomPosts: 9 |
New member Having trouble finding smartdrives in the UK , found 2 both where aluminium windings shall I go to the trouble of rewinding the coils in copper or use as stock? If I rewind the coils what gauge wire? I'm hooking it up to a Seahawks wawt Thanks all dirk |
||||
rustyrod Senior Member  Joined: 08/11/2014 Location: AustraliaPosts: 121 |
Have you read THIS ? Can you reconfigure your aluminium windings? Re connecting aluminium electrically I think may be a challenge, However something like EXAMPLE may be helpful and a steady hand. I would try one with the original windings, then when you have it working decide either to go again or a rewire in copper. Always Thinking |
||||
| Dirtydirk Newbie Joined: 14/02/2016 Location: United KingdomPosts: 9 |
Thanks that was my plan . I did have Hugh piggotts book on turbine construction with a good section on winding coils but I've lost it , thicker or thinner copper wire for slow speeds just can't remember the stock stator has 1mm wire but that's aluminium, so if enyone has eny thaughts please jump in |
||||
 Print this page |
