Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 03:49 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Solar : Solar Help

Author Message
rustyrod

Senior Member

Joined: 08/11/2014
Location: Australia
Posts: 121
Posted: 03:30pm 24 May 2017
Copy link to clipboard 
Print this post

I have two 90 watt solar panels in parralell for a 12 volt system.
Recently I noticed that they have stopped working.

However if I short the wires together for a moment or connect a 50 watt bulb across them, then after 15 to 20 seconds the panels start to work.
I must do this procedure every day between 9 and 10 am to get them up and working.
They have good output until sundown.

I have developed a major back problem and cannot walk let alone get up on the roof.
Is there anyone near Toowoomba in Qld who may be generous enough to come and have a go at them for me, Please?
Coffee will be supplied.
Always Thinking
 
Boppa
Guru

Joined: 08/11/2016
Location: Australia
Posts: 814
Posted: 09:22pm 24 May 2017
Copy link to clipboard 
Print this post

I'm heading down to nsw to rego my sisters car tomorrow, but probably back Sat (if it doesnt need repairs), if noone else has a chance before I get back, be happy to lend a hand (only about 20 min away)
 
rustyrod

Senior Member

Joined: 08/11/2014
Location: Australia
Posts: 121
Posted: 09:50pm 24 May 2017
Copy link to clipboard 
Print this post

Thanks, I have PM you
Always Thinking
 
yahoo2

Guru

Joined: 05/04/2011
Location: Australia
Posts: 1166
Posted: 09:39pm 25 May 2017
Copy link to clipboard 
Print this post

sounds like a classic dry jointed connection.

the other thing it might be is water inside the cable, I see it a lot with satellite cables, a parrot will take a little nip at the outer sheath up on the roof and the water will run down and fill up the cable inside then the DC will rust the core away.
I'm confused, no wait... maybe I'm not...
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024