Home
JAQForum Ver 24.01
Log In or Join  
Active Topics
Local Time 18:20 25 Nov 2024 Privacy Policy
Jump to

Notice. New forum software under development. It's going to miss a few functions and look a bit ugly for a while, but I'm working on it full time now as the old forum was too unstable. Couple days, all good. If you notice any issues, please contact me.

Forum Index : Solar : Bulk charging duration..

Author Message
pollenface

Regular Member

Joined: 01/09/2020
Location: Australia
Posts: 47
Posted: 01:03am 19 Oct 2020
Copy link to clipboard 
Print this post

The bulk charging duration for my Epever 4210AN controller is set to 2hrs by default.

I have a 24v/300ah agm bank (12v/600ah) which is usually hovering around 25.6v before the sun comes up.

I'm wondering how ideal that is for battery longevity or if I should shorten the bulk duration to around 30 minutes?

I have 800w of panels @ 86v.
Edited 2020-10-19 11:04 by pollenface
Off grid man caver
 
Solar Mike
Guru

Joined: 08/02/2015
Location: New Zealand
Posts: 1138
Posted: 01:23am 19 Oct 2020
Copy link to clipboard 
Print this post

Look up the spec sheet of your batteries, it will have graphs that indicate how long the CV charge period should be. The tapering current CV charge can be many hours to get to 100% charge, 2 maybe and is probably not long enough.
Your battery will only get damaged if the Bulk then CV voltages are too high, again depends entirely on battery chemistry spec.

Our 48V sealed lead carbon bank takes almost a half a day to fully charge to 100%. I much prefer Lifepo4, Bulk to float time 20 minutes.


Cheers
Mike
 
Print this page


To reply to this topic, you need to log in.

© JAQ Software 2024